![]() So far, there’s nothing different really from what we did in the last article. Looking at the neck pickup we have a similar situation: its green and bare wires are grounded and its output is connected to our hot signal in positions 3, 4 and 5. Black is the hot output, and it’s connected to the output to the volume control in positions 1, 2 and 3. Taking the bridge humbucker first, we can see that, as always, green and bare are grounded. This is the same as what we did in the last article. The black wire is grounded, and the white wire is connected to the output (the yellow wire to the volume control) in positions 2 and 4. Hopefully by now you shouldn’t be too intimidated when you look at a diagram like this! It’s important to note that in this diagram I’ve used red and white dotted lines to indicate that both the red and white wires from a humbucker go somewhere, and green and grey to indicate the green and bare wires. Here’s what our final wiring scheme looks like: So all we need to do (in addition to wiring the output of the various pickups up to the relevant places) is wire the switch so that it can ground out those wires in the correct positions.įor this guitar, we’ll just wire in a master volume and master tone. By now you’ll know that to split a humbucker to a single coil, the usual way is to connect that humbucker’s red and white wires to ground. This can be achieved with our superswitch. Neck humbucker split to single coil + middle pickup.Bridge humbucker split to single coil + middle pickup.Let’s say, for example, that we’re wiring up a guitar with two humbuckers and a single coil and we’d like to see the following combinations active as we sweep through the switch positions: It opens up many, many wiring possibilities. This gives us four separate five-way switches, all operated by a single lever. Hopefully you can see from this that it’s very similar to our two-throw switch from last time – but the switch has a whole new wafer attached, with another two poles on it. ![]() This allowed us to create some different wiring schemes for a Stratocaster, rather than just the standard one. This time we’re going to go a step further and look at a true “superswitch.” It looks like this: In the last article we got our first look at a five-throw switch with two poles. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |